Researchers in China have investigated how screen printing can degrade copper-plated silicon heterojunction (HJT) solar cells and have developed a modified screen design intended to reduce the damage. The study focuses on the photoresist-printing step and was published in Solar Energy.
Copper plating is attracting attention as a way to lower metallization costs and reduce reliance on silver in HJT cells. However, screen printing applies mechanical pressure and thermal treatment that can damage the cells’ sensitive passivating contact structures, increasing recombination losses and lowering conversion efficiency. Understanding the degradation mechanism is therefore important for optimizing metallization without sacrificing device performance.
Corresponding author Lang Zhou explained that photoresist printing for HJT cells differs fundamentally from conventional silver-paste printing. In silver-paste screens, openings occupy only 2–5% of the total area, while an emulsion layer covers the rest and prevents direct contact between the mesh and the wafer. Full-area photoresist coating, by contrast, typically uses a screen without emulsion coverage to ensure uniform resist deposition across the wafer. As a result, the mesh makes direct and extensive contact with the wafer during every printing cycle.
Previous investigations cited by the researchers showed conversion efficiency falling from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial solar cell production. The losses were mainly attributed to lower open-circuit voltage and fill factor, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the team identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the underlying passivation layers. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, suggesting damage to the amorphous silicon/crystalline silicon interface.
To reduce that damage, the researchers developed an emulsion buffer layer that prevents direct contact between the mesh and the wafer. They evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. The results revealed a trade-off: higher emulsion coverage provided more mechanical protection but impaired photoresist coating uniformity and ink distribution. A coverage ratio of 4.7% offered the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity.
The improvement was attributed to the emulsion layer keeping the screen mesh away from the wafer surface and thereby reducing cumulative mechanical damage to the passivation layers. Zhou said the findings show that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving manufacturing reliability for copper-plated HJT cells.
The work comes amid wider interest in copper metallization for HJT solar cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating, addressing adhesion, contact resistance and stability challenges at the indium tin oxide interface. Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT cell, a relatively small penalty compared with its silver-metallized counterpart; cells combining silver-copper paste on the front and silver contacts on the rear reached 23.95%. The results underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance are still needed.
